UV printers
we support.
Jigdesigner currently supports measured print beds for three UV printing platforms. Every supported bed uses the same 22mm jig grid, so compatible jigs can move between machines without being redesigned. Only measured beds are listed. Where a printable area has not been established, we say so rather than guessing.
The grid.
- Cell
- 22mm
- Foot
- 21.5mm
- Socket
- 4.75mm deep
- Clearance
- 0.25mm a side
Morpho UV printer.
Both run the same base-and-plate stack. A block printed for the A4 drops directly into the A3.
Morpho UV printer beds and jigs →xTool O1 Omni.
Both plates carry a replaceable tacky mat. A tray is laid on the bed and located by Pixel-Scan.
xTool O1 Omni beds and jigs →eufyMake E1.
Two flatbeds. The mini locks on with the machine’s own lever. Work on the standard 330 x 420 field is placed against a calibrated zero.
eufyMake E1 beds and jigs →HeyGears G1.
A 330 x 420 standard flatbed, the same size as the Morpho A3 and the Omni standard, so a tray printed for any of them fits, and a 330 x 130 mini flatbed. Sold as the G1 and the G1X, which are the same machine.
HeyGears G1 beds and jigs →